Easy Electronics xLogic Micro PLC - Writing and Starting the Circuit Program; Selecting Programming Mode

70
– Press,,ortomovethecursorinthecircuitprogram.
– PressOKtochangeto"Selectconnector/block".
– PressESCtoexitprogrammingmode.
● Youselectaconnector/block-whenthecursorappearsasasolidsquare:
– Pressortoselectaconnectororablock.
– ConfirmwithOK.
– PressESCtoreturntothepreviousstep.
Rule4:Planning
● Beforeyoustarttocreateacircuitprogram,youshouldeitherfirstcreateadesignonpaperorprogram
xLogicdirectlyusingxLogicsoft.
●xLogiccanonlysavecompleteandfaultlesscircuitprograms.
5.5Writingandstartingthecircuitprogram
Afteryouhavedesignedacircuit,youwanttowriteittoyourxLogic.Thesmallexamplebelowshows
howtodothis.
5.5.1Selectingprogrammingmode
YouhaveconnectedxLogictothepowersupplyandswitchediton.Thedisplaynowshowsyouthe
message:
SwitchxLogictoprogrammingmodebypressingESC.ThiswilltakeyoutothemainmenuofxLogic:
Thefirstcharacterinthefirstlineisthe">"cursor.Press and tomovethe">"cursorupanddown.
Moveitto"Program.."andconfirmwithOK.xLogicopenstheprogrammingmenu.