Easy Electronics xLogic Micro PLC - Circuit Program Input

73
5.5.3Circuitprograminput
Letusnowwritethecircuitprogram,startingattheoutputandworkingtowardstheinput.
xLogicinitiallyshowstheoutput:
YouwillseeanunderscorebelowtheQinQ001,whichisthecursor.Thecursorindicatesyour
currentpositioninthecircuitprogram.Youcanmovethecursorbypressingthe , , and keys.
Nowpressthe key.Thecursormovestotheleft.
Atthispointyouenteronlythefirst(OR)block.PressOKtoselecteditingmode.
Thecursornolongerappearsintheformofanunderscore;butinsteadasaflashingsolidsquare.xLogic
offersyouvariousoptionshere.
SelectGF(basicfunctions)bypressingthekeyuntilGFappears,andconfirmwithOK.
xLogicnowshowsthefirstblockfromthelistofbasicfunctions:
TheANDisthefirstblockofthebasicfunctionlist.
Thesolidsquarecursorpromptsyoutoselectablock.
Nowpress or untiltheORblockappearsonthedisplay: