Eaton BiWire Flexi - Battery Connections and Zone Cabling Procedures

EATON BiWire Flexi Installation Manual (PR215-216-520-03 15-03-16, PINSTFLEXIINST) March 2016 www.eaton.com 16
• Once the cable entry holes have been cut then fit the
cable glands to the back box.
• If the panel is being flush mounted, then insert the
panel into the recess feeding the cables through the
rear cable entry points.
• If the panel is being wall mounted then cut out the
required number of cable entry holes in the back using
a 20mm hole saw with pilot drill bit as shown in Figure
19. Fit the glands to the back box and pull through the
required cables.
• Using the mounting holes in the back box, drill holes
into the wall and insert wall plugs and secure the panel
to the wall as shown in Figure 17. Ensure any dust is
cleaned from the back box.
• Secure the PSE PCB back into the back box by following
the reverse instructions in Figure 16.
• Fit the PCB shelf and cables by following the reverse
instructions in Figure 14 and Figure 15.
• Fit the door back onto the back box by following the
reverse instructions in Figure 13
Installation Instructions
Figure 17: Cutting Cable Entry Holes
Figure 18: Securing the Panel to the Wall
www.acornfiresecurity.com
www.acornfiresecurity.com