Callisto 5PX G2 Service Manual
This specification is the property of Eaton Corp. and shall not be reproduced or copied or used as the basis for manufacture or sale of apparatus without permission
5 Failure analysis
5.1 Alarms
Ambient or NTC temperature is high
Battery level is below Remaining Capacity Limit threshold or Run
Time to Empty is below Remaining Time Limit threshold.
emergency stop was proceed
The load percent is > the overload level setting(default 105%)
LCM alarm is active because timer expired
UPS Internal fault: Main relay abnormal, NTC abnormal, or
Safety relay is failure.
Please refer below flow
chart: Fault 002
UPS internal temperature is high, over fault point
Please refer below flow
chart: Fault 004
Please refer below flow
chart: Fault 007
Please refer below flow
chart: Fault 105
Site wiring fault that can come of Phase neutral inversion on
single phase UPS
Please refer below flow
chart: Fault 107
Please refer below flow
chart: Fault 500
The charger voltage is>2.5VPC
Please refer below flow
chart: Fault 502
The charger voltage is<1.5VPC
Please refer below flow
chart: Fault 503
Battery need replacement OR is faulty
Please refer below flow
chart: Fault 607
Please refer below flow
chart: Fault 60D
Please refer below flow
chart: Fault 804
Please refer below flow
chart: Fault 805