Eaton EFX48 e-Fuse Series User Manual

Communications
Copyright © 2019 Eaton Corporation. All Rights Reserved.
IPN March 2019
83
Communications Options
The EFX e-Fuse Electronic Distribution has an Ethernet 100BaseT interface for communication
with a local or remote PC or laptop, or a Network Management System (NMS).
The standard communications options for an EFX48 are described in the following sections.
Ethernet Communications
Connections

EFX48 e-Fuse

Laptop/PC with:
• Web browser (see details on page 49), and/or
• Network Management System using SNMP (see details on page 87), and/or

Ethernet communications network.
EFX48 Setup
 The network administrator must assign a unique IP address to each EFX48 to be
connected to the network, or approve for the EFX48 to receive an address automatically
(using DHCP)
► To configure an EFX48 for Ethernet communications from the keypad
• Go to Settings > Network
• First choose Address Type . This can be either Auto – to receive an address from the
network server, or
IPv4 – to set a static IPv4 address
• For IPv4 (static) enter the IPv4 address , IPv4 netmask and IPv4 gateway address details
assigned by the network administrator.
• Web access is set to https by default. This can be changed to http , but read the
Cybersecurity section before doing so.

Eaton EFX48 e-Fuse Series Specifications

General

Brand	Eaton
Model	EFX48 e-Fuse Series
Category	Controller
Language	English