78
Change Log
Change Log
June 2012 Medium-Duty and Heavy-Duty Automated PTO Operating Instructions section:
UltraShift PLUS Countershaft PTO Operation section -
Mobile PTO Operation section -
Changed - item #4 from “Select the transmission PTO switch” to “Engage PTO”
Changed - Item #6 from “Release the service brake to engage the clutch and the PTO” to
“Release the service brake to engage the clutch and power the PTO”
September 2011 Added to Heavy-Duty Automated - 10 Speed table the following Models:
FO-10E310C-VAS, FO-12E310C-VAS, FO-14E310C-VAS, FOM-14E310C-VAS, FOM-15E310C-VAS,
FO-16E310C-VAS & FOM-16E310C-VAS
Added to Heavy-Duty Automated - 13/18 Speed table the following Models:
FO-16E313A-VHP
Corrected typo in call the model name for Heavy-Duty Automated - 13/18 Speed table for Model FO-
16E318B-MXP
Added to Heavy-Duty Automated - UltraShift PLUS - VCS and VMS table the following Models:
FO-18E313A-VHP & FO-20E313A-VHP
Added last note on Inertia Break Relocate Section
December 2009 Added K-3834 to UltraShift PLUS PTO pin out configuration notes
Updated and changed the PTO operation instructions for all automated transmission types
May 2009 Added UltraShift PLUS and MD Hybrid units to PTO configuration and PTO Interface sections
Reformatted/consolidated the PTO Interface Section
September 2007 Major updates.
Thru-Shaft changed to N/A on RTO-1X915 models on page 12.
Added UltraShift VCS, VMS, VXP, MXP, and MHP row to table on pg 23.
January 2007 Updated model nomenclature in Heavy-Duty Automated PTO Configuration table(s).
June 2006 New
Last Revised Date Description of Clarifications and Updates
To Next Page
Loading...
Need help?
General
