Chapter 1: Introduction
2 SC9000 EP medium voltage drives IB020001EN—February 2016 www.eaton.com
●
The SC9000 EP’s specialized design and patented thermal
management system yields the smallest footprint per hp in
the industry as a fully integrated drive. This size benefit
ensures installations in space limited electrical rooms,
eliminating the need for additional cable and conduit
installations, and in some cases, eliminating the need for
additional feeders required by our competitors
●
The SC9000 EP’s modular roll-in roll-out inverter design
significantly reduces Mean Time to Repair (MTTR), which
means that the SC9000 EP is built for maximum uptime
●
The test/burn-in procedure runs the drive for a minimum of
seven hours before shipping. This allows problems to be
detected and corrected before shipment. This process
exceeds the new IEEE 1566 requirements of 4 hour
minimum test/burn-in before shipment
●
Gateway for multiple communication protocols allow easy
communication with all commonly used control systems,
such as Modbus
®
, CANbus, PROFIBUS
®
DP, LonWorks
®
,
CANopen, DeviceNet
™
●
System bus, CAN, for the networking of drives
and peripherals
●
Simple programming via a PC. The NCDrive software
allows customers to upload and download drive
parameters, which can be changed, saved, and transferred
back to the drive and then printed or saved to a file for
future reference. These parameters can also be compared
to default values to determine drive configuration. Other
operator functions include the ability to set references,
start and stop the drive, and monitor and display signals
and values. The NCLoad tool gives customers the ability
to upload system, application, and option card software
intended for engineering, commissioning, and service
personnel
●
Programmable for custom applications for control and
I/O functions
●
Low air volume displacement
●
Low electrical noise
●
Volts/hertz control for single or multiple motor applications
●
Open-loop vector control
●
Isolation with fiber optics
●
Digital synchronization
●
Integrated automation interface
Revision
September 2015 Revision.
Documentation reference
For further information on installation and application, refer to
the applicable technical data, publications, and/or industry
standards. Download Eaton electronic information from
www.eaton.com.
Eaton contact information
For the location of your nearest Eaton sales office or
distributor, call toll-free 1-800-525-2000 or log on to
www.eaton.com. Eaton’s Electrical Services & Systems
(EESS) can be reached at 1-800-498-2678.
To Next Page
Loading...
