Eaton Scantronic i-on10 - Page 24

Configuring the System − Getting Started
Page 24
3. Remove the lid of the control unit (the tamper must be activated for the procedure to
work).
4. Disconnect the battery.
5. Place a jumper across the Kick-Start link.
6. While shorting the Reset Codes link, reconnect the battery and keep the short in
place until you see the following:


7. Enter a code you want to use for the installer code. Confirm when prompted.
8. Enter a code you want to use for the master user code. Confirm when prompted.
9. Remove the jumper across the Kick-Start link.
10. Close the lid.
11. Reconnect the mains supply.