System Options Menu
Page 51
If you change from 4-digit to 6-digit codes, two additional zeros are added to the end
of the existing installer code. If you change from 6-digit to 4-digit codes, the final two
digits are removed from the end of the existing installer code.
To comply with EN 50136-2, 6-digit access codes must be configured for access to
SPT functions at level 2, 3 and 4.
User 001
Defaults (removes) the master user settings, including the user access code,
proximity reader tag, etc. You are prompted to enter a new code for the master user.
Zones
Defaults all information relating to zones (e.g. zone types and attributes).
Outputs
Defaults all output configuration.
Setting Information
Defaults all setting options.
System Options
Defaults all options in the System Options menu.
Communications
Defaults all configuration for communications.
Factory Defaults
This removes all configuration from a control unit, including all names and stored texts, but
not the log.
To use the option:
1. Select Factory Defaults and confirm the operation when prompted.
2. Answer the configuration prompts. These are similar to those displayed when you
first powered-up the control unit (see page 18).
3. To delete all users, remove and reconnect all power to the control unit immediately
after using Factory Defaults (before you exit the Installer menu). You will need to
repeat step 2 when you re-apply power.
4. Exit the Installer menu. The system scans the bus and finds the devices (see page
32).
Installer Options
Installer Name
The installer name is recorded against installer events in the log. When viewing the log,
you can toggle between showing the user (installer) number and name using left/right
keys.
Installer Code
This code allows you to enter the Installer menu (which also carried out an Installer reset).
The Installer code does not allow you to set or unset the system.
To Next Page
Loading...
