Eaton Scantronic i-on10 - Appendix B: Installer Menu Map

Page 69
Appendix B: Installer Menu Map
Important: The defaults listed below enable the control unit to comply with EN50131
requirements. If you change those settings, the installation may no longer comply. If the
control unit does not comply with EN50131, you must remove any labelling that indicates
compliance.
Some options are available only if the relevant hardware is fitted, or for certain models of
control unit.
MENU Option
Factory Default
Notes
1 Detectors/Devices
Detectors
Program Zones
Zone 0...
Name
“Zone n”
Type
Not used
Attributes
All "off"
Available when zone is given a type
other than “Not Used”.
Some attributes are only available on
particular zone types.
Double Knock does not comply with
EN51031.
Address Bus
Device
Wired
Keypads
Address Bus Device
Edit Keypad
Keypad Kn-51...
Name
“Keypad Kn-nn”.
Key A
Name: “Key A”
Action: Full Set
Key B
Name: “Key B”
Action: Part Set B
Key C
Name: “Key C”
Action: Part Set C
Key D
Name: “Key D”
Action: Part Set D
Loudspeaker
Volume
Available only when a suitable keypad
is fitted.
Buzzer Volume
Backlight
Internal Prox
Enabled
External Prox
Disabled
Delete Keypad
Enable Keypad
Yes (all keypads enabled)
Replace Keypad
Radio
Keypads
KEY-RKPZ
Address Bus Device
Edit Keypad
Keypad Kn-51...
Name
“Keypad Kn-nn”.
Key A
Name: “Key A”
Action: Full Set
Key B
Name: “Key B”
Action: Part Set B
Key C
Name: “Key C”
Action: Part Set C
Key D
Name: “Key D”
Action: Part Set D
Internal Prox
Enabled