Eaton Scantronic i-on10 - Page 68

Log Messages
Page 68
"U--- O/P === On"
User defined output swittched off
by user n
"U-- Off-Site"
User n left Installer mode
"U-- On-Site"
User n entered Installer mode
"U--- PtSet # Exit"
User n started the exit process for
part set on partition n
"U-- Set Override"
User n overrode set fail
"U--- System Exit"
User n started the exit process for
full set on a part setting system
"U-- System PtSet #"
User n part set system
"U-- System Reset"
User n reset system
"U-- System Set"
User n set system
"U-- System Unset"
User n unset system
"U-- Time/Date"
User n changed time and/or date
"U-- Z== Omit"
User n omitted zone
"U--- Z=== HUA Omit"
User n omitted Hold Up Alarm zone
n
"U--- Z=== Omit Rst"
User n included Hold Up Alarm
zone n
"U--- Z=== Omit Rst"
User n included (restored) zone n
"Walk Test Complete"
Detector walk test completed
"Z== Closed"
Zone n quiescent
"Z== Open"
Zone n activated
"Z== Smoke Flt Rst"
Smoke detector at zone n has
been restored
"Z== Smoke Flt"
Smoke detector at zone n has fault
"Z== Smoke PSU Flt"
Smoke detector at zone n has
power supply fault
"Z== Smoke PSU Rst"
Smoke detector at zone n power
supply fault restored