Eaton Scantronic i-on10 - Test Menu; Testing Warning Devices; Keypad and Detector Testing

Page 61
Chapter 9: Test Menu
Sirens and Sounders
This option allows you to test the warning devices.
Press  to turn the device on. Press  to turn the device off. The display shows On
when the device should be operating and Off when the device should be silent.
Wired Sirens
This option allows you to operate all outputs of type Siren and Strobe.
Loudspeakers
You can use this option to test the sound from loudspeakers and keypads connected to
the system.
Wired Keypads
Use this option to test the sounders on the wired keypads.
KEY-RKPZ
Tests the sounders in KEY-RKPZ two-way radio keypads.
Wired Keypad
Use this menu option to test the keypad you are currently using.
When you start the test, the bottom line of the display shows the keypad name and bus
address. All four ABCD LEDs should glow. The LEDs around the navigation should all
glow red. Every time you press a navigation key, the LEDs change colour. Press all the
keys one by one. The display should show you the key you pressed.
To test the HUA keys, press them both at the same time. Note: An HUA alarm is not
generated.
Press  to leave the test.
Radio Keypads
KEY-RKPZ
Use this menu option to test the KEY_RKPZ keypad you are currently using.
This test behaves the same as for a wired keypad.
Walk Test
The walk test menu provides several different ways of organising a walk test.
When you select a Walk Test option (apart from Chime), the display shows the first item in
a list of the detectors available for test. Walk around the area you wish to test and trigger
each detector. If Chime is set to “On”, every time you trigger a detector, keypads and