Eaton Scantronic i-on10 - Page 70

Installer Menu Map
Page 70
Delete Keypad
Enable Keypad
Yes (all keypads enabled)
Replace Keypad
2 Outputs
Wired outputs
(
Panel
EDIT output
Name
Type
For outputs 1 and 3, the default
"Type" is "Siren". For output 2, the
default "Type" is "Strobe".
Polarity
Normal
Latched
No
For User-Defined output type.
Pulsed
No
Not available for dedicated siren and
strobe outputs.
Delay
0 seconds
Available when Pulsed set to “Yes”.
On Time
1 second
Zones
None
Available only for Zone Follow and
Zone Alarm output types.
Plug-by
outputs
EDIT PLUG-BY
O/P1...
Name
Type
O/P1: Fire Alarm
O/P2: Hold Up Alarm
O/P3: Burglar Alarm
O/P4: Open / Close
O/P5: Zone Omit (System)
O/P6: Tamper
O/P7: Confirmed Alarm
O/P8: General Fault
Polarity
Normal
Latched
No
For User-Defined output type.
Pulsed
No
Not available for dedicated siren and
strobe outputs.
Delay
0 seconds
Available when Pulsed set to “Yes”.
On Time
1 second
Zones
None
Available only for Zone Follow and
Zone Alarm output types.
3 Setting options
Full Set
Name
“Full Set”
Exit Mode
Timed Set
Settle Time
15 seconds
Available only if Exit Mode is “Final
Door Set”.
Confirm Set
On
Available only if Exit Mode is “Silent
Set”.
Exit Time
40 seconds
Available only if Exit Mode is “Timed
Set” or “Silent Set”.
Entry Time
40 seconds
Extended Entry Time
40 seconds
Siren Delay
0
Siren Time
15 minutes
Strobe on Set
Off
Strobe on Unset
Off
Part Set
B/C/D
(available only if a
zone has a Part Set
attribute)
Name
“Part Set B/C/D”
Exit Mode
Instant Set
Settle Time
15 seconds
Available only if Exit Mode is “Final
Door Set”.
Confirm Set
On
Available only if Exit Mode is “Silent
Set”.
Exit Time
40 seconds
Available only if Exit Mode is “Timed
Set” or “Silent Set”.
Entry Time
40 seconds
Extended Entry Time
40 seconds
Alarm Response
Siren
Siren Delay
0
Siren Time
15 minutes
Pt.set Final Exit
Final exit
Pt.set Entry Route
Entry Route