Detectors/Devices Menu
Page 37
To replace a keypad:
1. Select Replace Keypad at another keypad, and choose the keypad to replace. When
prompted, confirm the replacement.
2. Pair the replacement keypad with the base station.
3. Select Replace Keypad again, and choose the keypad you replaced (the display
shows "Add" in the bottom-right corner).
4. Hold down the A and ļ keys at the new keypad. The control unit assigns the bus
device address of the keypad you removed to the new keypad, along with the name
and other settings from the old keypad. The new keypad will not need any further
configuration.
The control unit assigns the bus device address of the keypad you removed to the
new keypad, along with the name and other settings from the old keypad. The new
keypad will not need any further configuration.
To Next Page
Loading...
