Eaton Vickers V Series - VT Thru-Drive Rear Mountings Installation Dimensions; BP Rear Mounting

27
**VT Thru–Drive Rear Mountings Installation Dimensions
**VT ThruĆDrive Rear Mountings
BP" Rear Mounting
174,8
(6.88)
Ø .563 thru flg BP" spacer
to .500Ć13 UNCĆ2B thd. of
B" adapter 2 places
(inch threads)
Pump
Model
Dimension A"
Dimension
L"*
**VTBPS **VTBPM
25VTBP 261,9 (10.31) 261,9 (10.31)
45,6/43,2
(1.80/1.70)
Not SAE std.
35VTBP 284,5 (11.20)
284,5 (11.20)
45,6/43,2
(1.80/1.70)
45VTBP 317,0 (12.48) 347,2 (13.67)
45,6/43,2
(1.80/1.70)
* Caution: Dimension L" is important and must be observed.
Ø
133,4
(5.25)
A"
To mounting flange face
Snap ring
AS 568Ć234
OĆring req'd
Output
coupling
13T 16/32
DP Spline
NOTE: These units accept a Vickers
pump as below which conforms to
flange code 101Ć2 in ISO 3019/1 (SAE
J744C Jul88) and has a Vickers type 9
shaft.
46,05
(5.75)
73,02
(2.875)
L"
84,1
(3.31)
101,68
(4.003)
Ø
AS 568Ć155
OĆring req'd
10,16
(.400)
63,5
(2.50)
Not SAE std.
Not SAE std.
66,7
(2.62)
**VTBP
The following Vickers shaft selection
will comply with the above:
Rear Pump
Model
Shaft
PVE12/19/21 Piston pump 9