Need help?Do you have a question about the Eaton Vickers V Series and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | Vickers V Series |
| Category | Water Pump |
| Language | English |
Details on volumetric efficiencies, sound levels, and operating pressures for cost-effective pumps.
Overview of Intravane pumps, covering longer life, increased productivity, and industrial application compatibility.
Highlights key advantages like high pressure capabilities, low noise, and design flexibility for various configurations.
Defines the pump series based on displacement ranges (e.g., 20V, 25V).
Lists rated capacities in cm³/r and in³/r for various frame sizes.
Details standard and metric ISO pilot shaft options and their configurations.
Specifies pump series for double configurations by shaft and cover end displacements.
Provides displacement values for both shaft and cover end pumps in double units.
Details available shaft types for double pump models.
Defines thru-drive pump series based on displacement.
Lists displacement values for thru-drive pump models.
Details shaft options for thru-drive pump configurations.
Presents average sound levels in dB(A) for various models at different RPMs.
Recommends suitable hydraulic fluid types and viscosity grades for optimal pump performance.
Step-by-step guide for safely starting the pump, including priming and air bleeding.
Details recommended fluid cleanliness levels for component life and system performance.
Information on seal compatibility with various fluid types.
Flow charts showing delivery vs. speed for 20V pumps with displacements 5 and 12.
Input power charts showing kW/hp vs. speed for 20V pumps with displacements 5 and 12.
Flow charts showing delivery vs. speed for 20V pumps with displacements 2 and 9.
Input power charts showing kW/hp vs. speed for 20V pumps with displacements 2 and 9.
Flow charts showing delivery vs. speed for 20V pumps with displacements 8, 11, and 14.
Input power charts showing kW/hp vs. speed for 20V pumps with displacements 8, 11, and 14.
Flow charts showing delivery vs. speed for 25V pumps with displacement code 10.
Flow charts showing delivery vs. speed for 25V pumps with displacements 12 and 17.
Flow charts showing delivery vs. speed for 25V pumps with displacements 14 and 21.
Flow charts showing delivery vs. speed for 35V pumps with displacements 25 and 35.
Flow charts showing delivery vs. speed for 35V pumps with displacements 30 and 38.
Flow charts showing delivery vs. speed for 45V pumps with displacements 42 and 60.
Flow charts showing delivery vs. speed for 45V pumps with displacement code 45.
Flow charts showing delivery vs. speed for 45V pumps with displacement code 50.
Installation dimensions for VT Thru-Drive rear mountings, type 'A'.
Installation dimensions for VT Thru-Drive rear mountings, type 'B'.
Installation dimensions for VT Thru-Drive rear mountings, type 'BP'.
Installation dimensions for VT Thru-Drive rear mountings, type 'C'.
Details and dimensions for straight key shafts used with thru-drive pumps.
Details and dimensions for splined shafts, including spline data.
Mounting options for VM and VT*M pumps using ISO 3019/2 metric pilot flanges.
Torque ratings for single pumps up to maximum pressures and speeds.
Torque ratings for double pumps, considering combined cartridge loads.
Torque limits for thru-drive pumps and their rear-mounted components.
Guidance on suitable drive types and alignment for Vickers units.
Requirements for customer mounting pads, including pilot diameter and face squareness.
Lists moment of inertia values for various pump models.
Provides approximate weights for different frame sizes of vane pumps.
To Next Page