EBS 6900 - Printing Parameters: Reprints and Mode Settings

The BOLTMARK
®
II‑series PrinTers
Basic OPeraTing insTrucTiOns
242018/02/27#2.0EN
Setting
Printing ParameterS
Text rpt. : 1 The number of reprints of a text on an object.
Rpt.dist. : 30,0 mm
Distance between the beginnings of successive reprints (if Text rpt.
> 1).
Conv. direct. : LEFT
The direcon (le, right) in which objects move in front
of the printhead.
Oset interv : Day
A unit by which the date to be printed is shied relave to the cur-
rent date. The parameter is used to print a so called expiraon date
by the applicaon of the special register Date+os..
Oset : 100
A value by which the date to be printed is shied relave to the cur-
rent date; it is given in units selected with the prinng parameter
Oset interv. The parameter is used to print a so called expiraon
date by the applicaon of the special register Date+os..
RollTimeHH:MM :
00:00
Seng forward the me at which the date change occurs, from
noon to another me during the day. The parameter is used to print
the date by means of the special register WILL Date.
Counter delta : 1
Increment for an incremental counter or decrement for a decremen-
tal counter. The parameter is used by the Up counter and Down
count. special registers.
Row repet. : 1 The number of reprints of every column of a text.
Print every n : Oponal parameter.
Mode :
NORMAL
To acvate prinng at maximum speed.
The parameter is available only for SERVICEMAN .
• Not every combinaon of the Matrix height, Speed Level and Height (pix) parameters is
permied. If a forbidden combinaon is selected, an error message is displayed. To display
the whole message, select the icon on the funcon idencaon icon bar.
• If you nd it dicult to set the global prinng parameters, it is recommended that the
default parameter sengs be applied by pressing the icon. Most of texts can be printed
at the default sengs of the prinng parameters.
• If Generator = GEN, an object must move in front of the printhead so that a correct print
is made. Otherwise, a vercal bar is printed.
• If Generator = SHAFT, the printhead will print only when a rotary encoder is connected to
the conveyor belt and the belt travels.