EBS HandJet EBS 250 - Maintenance, Storage, and Transport

20111028#4.2 EBS Ink-Jet Systeme
EN
 29
EN
You can quick-load the project library
from the computer disc to your printer
with two successive commands Open
project library and Send and save
text library.
 Maintenance, Storage
and Transport
6 It is recommended that the outer
face of the print head, especially
the nozzle plate 2, and possibly
the guide rolls 1 and 3 should be
washed in order to remove the
remnants of ink and dirt after the
work has been finished and the
printer has been switched off.
The washing should be done in
the following way:
• Place the HANDJET printer
on its side and tilt its face
downwards carefully (see
the drawing below); in such
a position dirty wash-up can
flow freely out of the printer,
• Place a piece of absorptive
cloth or a metal vessel, e.g.
a tray, under the printer face,
• Wash the printer face with the
use of a wash-up atomiser.
!
If the printer face is washed in a
different way than that shown
above, then wash-up may get in to
the printer’s movable, bearing-
based parts or inner electronic
subassemblies unintentionally. In
effect, the roll guides may seize or
ever lockup permanently and the
(shaft-encoder) position sensor and
other electronic subassemblies may
get damaged.
6 If the printer remains idle for a
longer period (over 3 weeks), ink
may partially dry in printer com-
ponents. Therefore follow the
storage instructions given below
not to be disappointed when you
try to use your printer afterwards:
• if the printer has already
been used before, store it
with ink container 10 fas-
tened to it,
• protect the printer against
dust, dirt, any influence of
aggressive vapours and
gases and excessive tem-
perature and moisture. Ide-
ally, place the printer in a
polyethylene tight bag, re-
move air from the bag and
close it tightly. Then place it
in the packing case.
6 The printer should be stored and
transported in the packing case
delivered with the printer. During
normal operation avoid exposing
the printer to strong mechanical
shocks (protect the printer, espe-
cially nozzles 2, rolls 1 and 3 and
panel 9 against impact, falling
onto hard surfaces or scratching
with sharp objects).