EBS LX20G - Old Protocol Commands

LX20G_Manual_en_v2.1
Page 65 /
69
Samples of commands and device reaction:
Parameters setting:
1111█APN=general.t-mobile.uk█SERVER=89.112.43.78█PORT=6670█
SMS=500445566█SMSPERIOD=25
Parameters verification:
Inquiry: 1111█GETCFG
Answer: 89.112.43.78:6670,general.t-mobile.uk██,
Inquiry: 1111█GETPARAM=SMS
Answer:: 500445566
9.2. OLD PROTOCOL
The following format of message is acceptable allowing to send some commends
with one SMS (every command shall be separated with SPACE):
SERVICE CODE█COMMAND█COMMAND█..........
Where:
SERVICE CODE - device service code
█ - SPACE
COMMAND - order (see the table below)
List of commands
NEW
Switch device operating in PX emulation mode into encoding
protocol mode.
STAT
Enquiry regarding actual module condition
VER
Gets device firmware version
TMP1
Switches on OUT1 output
*
TMP0
Switches off OUT1 output
*
AUX1
Switches on OUT2 output
*
AUX0
Switches off OUT2 output
*
INT_ON
TMP (sabotage) input lock
IN1_ON
1 input lock
IN2_ON
2 input lock
INA_ON
All inputs lock (with no impact on sabotage input)
INT_OFF
TMP (sabotage) input unlock
IN1_OFF
1 input unlock
IN2_OFF
2 input unlock
INA_OFF
All inputs unlock (with no impact on sabotage input)
KILL
GSM modem reset
*
In PX protocol output OUT3 can not be switch remotely.