PAS-225 VP OPERATION
X7732274200 27
© 5/2017 ECHO Inc.
ENGLISH
Edger Operation Techniques
1. Before edging, water the area
to soften the ground to make
edging easier.
2. Before edging, check the area
and remove all obstacles and
objects that could be thrown.
3. Plan to edge regularly to make
it easier to keep a neat edge
and to avoid having to make
more than one pass.
Note: Blade depth may have to
be adjusted due to differ-
ences in height between
the hard surface and the
top of the grass.
Never adjust blade height with engine running, otherwise seri-
ous personal injury may result.
4. Loosen adjustment knob and
adjust the blade's depth of cut
to produce a fine cut between
sidewalk and grass using a
minimum blade depth, usually
with about 13 mm (0.5 in.) of
the blade into the ground.
Tighten adjustment knob.
5. Before edging, plan your direc-
tion of travel so that the unit will
always be positioned on your
right side and so that you walk on a hard surface whenever possible.
6. Hold edger as shown.
Before edging, be sure to read and understand the entire Oper-
ator's Manual to avoid serious injury.
To Next Page
Loading...
Need help?
General
