Po w e r Pr u n e r
TM
oP e r a T o r 's Ma n u a l
23
0.65 mm
(0.026 in.)
s p a r k p l u g
Level 2.
Parts Required: Spark Plug NGK BPMR-8Y
IMPORTANT
Use only NGK BPMR-8Y spark plug otherwise severe engine
damage may occur.
1. Remove spark plug and check for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).
c o o l I n g s y s t e m
Level 2.
Parts Required: None if you are careful.
IMPORTANT
To maintain proper engine operating temperatures, cooling air
must pass freely through the cylinder n area. This ow of air
carries combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the
cylinder.
• Dust and grass build up on the outside of the cylinder. This build up
insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages is considered “Normal Mainte-
nance.” Any failure attributed to lack of maintenance is not warranted.
To Next Page
Loading...
