EchoStar DVR-5000 HDD - Page 66

Section 7 Troubleshooting
Page 7 - 2 EchoStar DVR-5000
© 2001 EchoStar International Corporation
All rights reserved
2. Bad picture or noisy
sound in the TV or radio
mode.
■ Bad reception of the
signal.
■ Make sure the dish and
LNB are clean and
correctly adjusted. Do
any necessary work.
■ Signal interference with
UHF-installation.
■ Check the UHF settings.
Make sure you use the
correct channel. Please
refertotheTV/radiouser
guide.
3. The TV shows a
No Signal message.
■ Bad reception of the
signal.
■ Make sure the channel
selected transmits.
■ Make sure the correct
dish or LNB is selected.
■ Make sure the dish and
LNB are clean and
correctly adjusted. Do
any necessary work.
4. There is no Dolby digital
(AC-3)soundtomyother
equipment.
■ The equipment is
connected to the receiver
with a RCA or SCART-
cable only.
■ Connect the
S/P DIF connector of the
receiver to the Dolby
digital input of the
receiving equipment.
5. I cannot view or listen to a
scrambled channel.
■ The CI-module/smart
card is not valid.
■ Insert, for this service, a
valid CI-module/smart
card.
■ The CI-module/smart
card is not (correctly)
inserted.
■ Insert the CI-module/
smart card correctly.
6. I cannot find a channel
which should be there.
■ The group or sort option
is set.
■ Set the group and sort
mode to none.
■ Youareinthewronglist. ■ Check the all channels
list and select the correct
(favorite) list.
■ The channel is hidden. ■ Unhide the channel.
7. The TV shows a popup:
■ You have selected an
empty (favorite) list.
■ Press the WHITE key
Select the add option.
■ Press the GREEN key
Select the Current Sat or
All Channels list.
Problem Possible cause What to do?