Eclipse CD5425 - Before Installation; Components; Installation Angle

109
Before installation
Before installation
Components
Installation angle
In order to maintain proper functioning, install the unit within an angle of 30
degrees from horizontal (standard). If this is not done, sound skipping or
ejection of the CD may occur.
● Note ●
Be sure to disconnect the vehicle battery's negative terminal
before installing the receiver.
No. Item Q'ty
1 Main unit 1
2 Mounting sleeve 1
3 Side bracket 2
4 Rear bracket 1
5 Bezel 1
6 Bushing 1
7 Self-tapping screw (6 x 16 mm) 1
8 Stud bolt 1
9 Flat head screw (red: 5 x 8 mm) 4
10 Hex-head bolt (red: 5 x 8 mm) 4
11 Hex-head bolt (6 x 20 mm) 1
12 Hex nut (5 mm) 1
13 Hex nut (6 mm) 1
14 Interconnecting cable 1
FRONT
STANDARD
WITHIN AN ANGLE
OF 30 DEGREES
CD5425.book 109 ページ ２００４年１２月１１日 土曜日 午後５時９分