66
How to operate the tuner
Changing the reception sensitivity for automatic
scanning
The deck lets you select the reception sensitivity to be used for automatic
scanning of stations. The two sensitivity modes available for this deck are
AUTO mode and DX mode.
Check that the deck is in standby mode.
Press and hold button [1], then the [FM AM] button, and
hold both for more than three seconds.
The mode switches between AUTO mode and DX mode each time
the buttons are pressed.
When an optional HD Radio tuner unit is connected, reception
sensitivity is set to the AUTO Mode. The DX Mode is unavailable.
(U.S.A. only)
AUTO Mode
During automatic scanning, the reception sensitivity switches
automatically to one of two levels. Initially the reception
sensitivity is set to the low level so that only stations with
strong signals are received. If no stations could be received,
the reception sensitivity is increased so that stations with
weaker signals can also be received.
DX Mode
Because the reception sensitivity for automatic scanning is
set to the high level from the start, even stations with weaker
signals can be received. (Signal crossover may result in
some stations being hard to hear.)
Button [1]
[FM AM] button
CD5425.book 66 ページ ２００４年１２月１１日 土曜日 午後５時９分
To Next Page
Loading...
Need help?
General
