Eclipse EA500 User Manual

(17) Press the small right knob to return to the SETUP 1 page after UNITS / MAG VAR
configuration is set.
(18)
Rotate the large right knob to select Position / Map Datum and press ENT.
(19) Using the large right knob to select fields as necessary, the small right knob to make
selections, and ENT to confirm selections, set up the POSITION FORMAT / MAP
DATUM configuration as shown in Fig. 215.
(20) Press the small right knob to return to the SETUP 1 page after POSITION FORMAT /
MAP DATUM configuration is set.
(21) Rotate the large right knob to select Date / Time and press ENT.
(22) Using the large right knob to select fields as necessary, the small right knob to make
selections and enter values, and ENT to confirm selections, set up the DATE / TIME
configuration as shown in Fig. 216.
(23) Press the small right knob to return to the SETUP 1 page after DATE / TIME
configuration is set. Press the small right knob again to dismiss the cursor on SETUP
1.
(24) Rotate the small right knob to select the fourth page of the AUX page group (SETUP
2).
(25) While on the third page of the SETUP 2 page, press the small right knob to turn on
the cursor. Press ENT to select DISPLAY.
(26) Using the large right knob to select fields as necessary, the small right knob to make
selections and enter values, and ENT to confirm selections, set up the DISPLAY
configuration as shown in Fig. 217.
(27) Press the small right knob to return to the SETUP 2 page after DISPLAY
configuration is set.
(28) Rotate the large right knob to select Nearest Airport Criteria and press ENT.
(29) Using the large right knob to select fields as necessary, the small right knob to make
selections, and ENT to confirm selections, set up the NEAREST AIRPORT
CRITERIA as shown in Fig. 218.
(30) Press the small right knob to return to the SETUP 2 page after NEAREST AIRPORT
CRITERIA configuration is set.
(31) Rotate the large right knob to select SBAS Selection and press ENT.
(32) Using the large right knob to select fields as necessary, the small right knob to make
selections, and ENT to confirm selections, set up the SBAS SELECTION
configuration as shown in Fig. 219.
(33) Press the small right knob to return to the SETUP 2 page after SBAS SELECTION
configuration is set.
(34) Rotate the large right knob to select Data Field Configuration and press ENT.
(35) Using the large right knob to select fields as necessary, the small right knob to make
selections, and ENT to confirm selections, set up the DATA FIELD
CONFIGURATION as shown in Fig. 220.
EA500 Aircraft Maintenance Manual — 06-117751
Temporary Revision No. 34-21
EFFECTIVITY: 0001-0262, POST SB 500-99-005; AND
0266-0267; ALL POST MB 500-31-018
34-50-10
CONFIG A
Page 209
Sep 30/20
© 2020 Eclipse Aerospace, Inc.

Eclipse EA500 Specifications

General

Brand	Eclipse
Model	EA500
Category	Aircrafts
Language	English