Page 14
3.3.2. Condor Controller Installation
Select a location as close as possible to the Pump Cabinet but also access for programming. This will allow
for easier operation and maintenance. The visual and audible alarms comes from the Condor Controller.
1. Choose a location allowing visible display of the controller with the keypad accessible. Please avoid
locations where steam and splashing water occur.
2. To remove Condor Controller from mounting bracket, pull up on center tab and slide parts apart.
3. Using the wall mounting bracket as a template, mark 2 holes on the wall using a pencil.
4. Drill (2) holes using 1/4-inch drill bit and insert plastic wall anchors.
5. Using a screwdriver, mount bracket to wall.
6. Remove back cover to access RS-485 cable connections.
7. Tilt Condor Controller’s top forward and slowly guide Controller onto bracket.
For Dual Lock (Tape) Installation
1. Cut (4) 3-inch Dual Lock strips (provided in installation kit).
2. Squeeze (2) pieces of the Dual Lock strips together.
3. Apply the Dual Lock strips to back of Condor Controller bracket by removing the adhesive backing.
4. Remove the adhesive backing and stick unit to desired mounting location- on wall or machine.
For L-Bracket Installation - Optional
1. Mount L-bracket to top or side of washing machine. You may also use the Dual Lock tape.
2. Twist and lock Condor Controller’s bracket into the L- bracket.
3.3.3. Formula Select (FS) Installation
The FS is intended to be mounted to the front of the laundry washer as an operator accessible location using
the wall bracket or Dual Lock tape (provided in installation kit). The optional mounting L-bracket (ordered
separately) can also be used, similar to the Condor Controller Installation- see above.
To Next Page
Loading...
