Page 7
1.3.5. Pump Cabinet
The Pump Cabinet is the product dispenser that sprays hot water into 3 solid product capsules. The product
solution gravity drains into the pump, then the pump pushes the solution through a washer selection
manifold and 1 of 3 valves will open to determine which washer the product goes to. The system delivers
product(s) to the correct washer based on the programmed values. The system continuously measures the
product and will notify the operator when the capsule is empty. The empty alarm consists of an audible
alarm and icon on both the Condor Controller and the Formula Select. Before each product spraying, there
is a pre-flush and post-flush of water only- to clear out the sump and pump’s tubing to prevent products from
mixing.
Hydraulic Diagram inside Pump Cabinet
Hot Water
Back flow prevention RPZ / BA
To Next Page
Loading...
