Page 26
3.7. Solid Bleach Product Housing
3.7.1. Introduction
The optional bleach product housing (9259-1115) is to be used only with the Aquanomic Oxygen Bleach
product. All other products for the middle pocket do not required this housing and can be used directly with
the Aquanomic system. The plastic housing is included in the Aquanomic EU dispenser, however it will
need to be installed at the account.
3.7.2. Installation
1. Locate the middle pocket on the Pump Cabinet and remove the (2) screws for the capsule safety switch,
as shown below. Keep these screws as you will need them when installing the bleach housing.
2. Lift the safety switch assembly out of the sump and remove the Reed Switch by pulling sideways.
To Next Page
Loading...
