Page 25
Plumbing
1. Inside the Pump Cabinet, cut the 3/8-inch clear tubing which supplies water to the detergent valve
approximately 7 cm before the detergent valve.
2. Feed the 3/8-inch clear tubing with the Tee connector located in the 4th Product Cabinet through the top
hole on the left side of the Pump Cabinet.
3. Connect the cut tubing into the T connector.
4. Remove the plug from the sump drain hose (located above the pump inlet) in the Pump Cabinet.
5. Feed the 4th Product Drain hose through the bottom hole on the left side of the Pump Cabinet.
6. Attach the 4th product drain hose to Pump Cabinet’s drain hose using the connector tube and two hose
clamps as shown below. Be sure drain tube is not kinked. Shorten length if necessary by cutting 4th
Product Drain hose.
To Next Page
Loading...
