Ecolab Aquanomic - Operation; General Information

Page 3
Materials Ordered Separately for Installation
• 10mm O.D. flexible copper tubing or G3/8 stainless steel braided hoses.
• 1/2-inch O.D., 3/8-inch I.D., Polyflo (PolyEthylene, PE) tubing used for product delivery from the
Pump Cabinet to the laundry machine(s). This rigid tubing withstands higher temperatures than soft
EVA.
• The 5/8-inch I.D. Mayon tubing used for the overflow is not included in the installation kit.
• 1/2-inch conduit or Seal-Tite with connectors and fittings (hardwired power source and supply
signals).
• Electrical plug for power cord must be sourced and installed separately.
• A main switch (EBS Nr. 10010678) or non symmetric plug is mandatory.
• Proper wall anchors or toggle bolts should be used on sheetrock walls.
• Water Tempering Valve Kit if the account hot water temperature is greater than 60°C.
• Optional 15m (50-feet) RS-485 communication cable are available.
• Optional L-brackets for mounting Condor Controller or FS modules.
1.0 System Introduction
1.1 Preface
This manual has been written and illustrated to present the basic installation and servicing instructions of the
Aquanomic EU solids dispenser. This manual applies to current units. Future versions may have additional
features; check unit packing for the latest revision.
Guidelines will be suggested in reference to the preferred method of installation. However, the variety of
equipment and the surrounding environment will dictate the actual installation of the Aquanomic EU unit.
These installation, operation and servicing instructions are for use by qualified personnel only. The Aquanomic EU system is intended to be
installed by an experienced, qualified technician. The installation must be made in accordance with all applicable and local plumbing and
electrical codes. The dispenser must be properly plumbed to a laundry washer / extractor. The washer extractor must have a properly
installed drain system or overflow protection system.
The remarks WARNING, CAUTION and NOTICE have the following meanings in this manual.
This heading refers to a hazard or unsafe practice which can result in severe personal injury or death.
This heading refers to a hazard or unsafe practice which can result in personal injury or product or property damage.
This heading is used when a particular piece of information needs to be highlighted.