Ecom j2kn pro - Page 32

Page 32 ecom-J2KN
pro
Pitot factor (selection after pressing <OK>):
-Input of pitot factor for flow rate calculation (rbr flow probe = 0.93).
If the flow rate calculation is not needed, set pitot factor to 0
Printout (selection after pressing <OK>):
- Text input for printout on measurement protocol (8 x 24 characters)
- Input the text of line 1 as follows:
1. Activate character selection list with <OK>.
2. Select keyboard type with <F3>
(4 different keyboards available).
3. Use the cursor keys to select the desired character
(selected character is outlined by black background).
4. Confirm selection while pressing < OK >.
5. Repeat procedure until desired text is complete.
6. Once input for line 1 is completed, deactivate the characters
selection mode with <F1> and move to the second line with the
cursor key <Down>.
7. Once all lines have been processed as desired, exit the menu
with <ESC>.