Ecom j2kn pro User Manual

ecom-J2KN
pro
Page 33
11. Control
The electrochemical sensors alter their output values along the op-
eration period. The programme controls the sensors and corrects
drifts. If the drifts and the correlated measurement errors increase,
an error message is displayed. In this case the corresponding sensor
must be changed by an authorised service centre. The control menu
informs about the current status values for the sensors as well as
about (page 2 and 3 with cursor keys <up/down>):
-rbr- Messtechnik O2 10744 mV
Am Großen Teich 2
CO 7 mV
58640 Iserlohn Batt 4.50 V
--------------------- Bat.B 6.09 V
Tel.: 02371-945-5
Fax : 02371-40305
eMail : info@rbr.de
Operation hours : 8.45 hrs
Serial no. : J2KN 12345
Service tel. : 02371-945-5
Programm version : V3.0 / 12.07.10
Next unit check : 20.04.11
Control
Next service
centre
Serial number
Software
version
Radio quality
Sent frames
(radio)
Received
frames (radio)
Number of
frames (USB)
Accu voltage
control module
basic module
Operation
hours
Recommended
maintenance
date
Number of CO-
switch
-
offs
ppm hours of
CO sen
sor
Number of
errors
Number of
instrument
switch
-
ons
Date of last service
O2 10744 mV
CO 7 mV
Batt 4.50 V
Bat.B 6.09 V
Operation hours : 8.45 hrs
Serial no. : J2KN 12345
Service tel. : 02371-945-5
Programm version : V3.0 / 12.07.10
Next unit check : 20.04.11
Control
20
4.2 /s
4.2 /s
0.0 /s
1 X
22 ppm
4 X
11 X
O2 10744 mV
CO 7 mV
Batt 4.50 V
Control
Last service (history)
19.12.12 133 hrs
--.--.--
2.24
ltr /
min
Gas pump is running
Air valve is open
CO purging is running
Gas cooler ready for use
Heated hose ready for use
Heated head ready for use
Probe heating is switched on
Gas flow
(liter per minute)
Radio mode
battery oper
a
tion
Calibration phase

Ecom j2kn pro Specifications

General

Brand	Ecom
Model	j2kn pro
Category	Measuring Instruments
Language	English