ECOVACS WINBOT - Cleaning and Replacing Cleaning Cloth

Enjoy smarter life
ENG - 85
ENG
6.5 feet
The Remote has a series of functions which you need to become
familiar with while the unit is on the window and within easy reach.
While you read the following instructions and operate the unit by
the Remote, you will see how easy it is to use the Remote and
control the unit.
1. RESET button – should the unit NOT work in any ofthe following
ways, the RESET button can be pressed to restart the product and
make the product restore to the factory default state .
2. Start/Pause button – Starts or Stops the product.
3. 4. 5. 6. Arrows – each arrow indicates the direction the unit will
travel, remembering the UP arrow is the Front of the Unit.
Operation – the Remote will work when within 6.5 feet ofthe unit.
The front of the Remote MUST be pointed at the Red spot on the Top
Front ofthe unit or on the Bottom ofthe unit behind the Cleaning Pad.
Should a problem occur with the Remote Signal, make sure that
no other infrared devices are in use in the immediate area .
6. DAY-TO-DAY STORAGE
• Storage ofthe unit must be away from high temperatures as
the plastic and electronic components can be affected.
• Do not store the unit close to liquids where the liquid might be
spilled onto the unit and get inside and damage the unit.
• Pay attention to the maintenance requirements ofthe unit as
spelled out in that section ofthe Instruction Manual.
7. PRODUCT MAINTENANCE
7.1 Cleaning the Unit
The Unit must be in the OFF position and unplugged from the
electrical source.
The Unit may NOT be cleaned with any volatile liquid such as
solvent, gas, etc. or a detergent containing acidic or pine sole
additives as they will negatively affect the plastic.
7.2 Cleaning and Replacing Cleaning Cloth
After each cleaning or should the Pad get really dirty before nishing
the cleaning of the window, the Pad can be rinsed in clear warm
water. Be careful of detergent you might use to wash the pad as
you do not want to leave a soapy lm on the pad that will not allow
the Pad to properly clean the window. After thoroughly dried
(generally dry for 24 hours), re-install the pad on the unit.