ENG - 86
7.3 Squeegee
Squeegee maintenance
After each use, gently wipe the Squeegee with a damp cloth to
remove residue from its surface. Awet cloth will allow water to get
inside the unit and cause damage to the internal components.
A replacement squeegee may be purchased by going to our Web
Site or calling our service number.
Squeegee replacement
1) Push the Squeegee to the centerfrom
each end of the Squeegee, then take
it off.
2) Replace it with a new one: put the new
one into the groove and pull the end
ofthe Squeegee to each side.
7.4 Cleaning Driving Treads
After each use inspect the Treads for possible accumulation of dirt.
The total tread can be inspected by using the remote and pressing
the Fonivard or Reverse arrow. Clean any dirt with a soft damp pad.
NOTE: Dirty treads can negatively affect the function ofthe treads
driving the unit on the w|ndow.
7.5 Infrared Transceiver
The infrared transceiver - dark red lense - is located on the Top
and Bottom of the product. It is recommended to wipe the infrared
transceiver lens carefully with a dry soft cloth after each use and
before using the product to clean the window.
7.6 Cupule
Cupule maintenance
The Cupule assembly is a basic part ofthe units function and is
located on the bottom of the unit. After each use, you need to
inspect the gasket surface to make sure it is not torn or cut. Any
debris that is stuck to the surface must be carefully removed.
Cupule replacement
1) Take the cupule off with a screw driver.
2) Replace it with a new one.
To Next Page
Loading...
