ECOVACS WINBOT - Quick User Guide Overview; General Warnings and Setup Steps; Key Safety Instructions and Precautions

ENG - 70
QUICK USER GUIDE
Important notes to help you get a quick start.
WARNING
If Winbot is used to clean a window above ground level, the Safety Pod MUST be used.
Winbot must be used in strict accordance with the directions in the Instruction Manual.
ECOVACS can not be held liable or responsible for any damages or injuries caused due to
improper use.
1) Make sure that there is enought power cord for the WINBOT to clean the entire window
without restricting its movement. If there is not enough cord, it is not safe to use the
WINBOT on that particular window until a WINBOT Extension Cord is attached.
2) Loop one end of the Safety Rope around the Safety pod´s channel and pull it tight.
3) Loop the other end of the Safety Rope to the power connector on the power cord and
tighten.
4) If an Extension Cord is attached, the Safety Rope must be tied to the power connector on
the Extension Cord. Note: Do NOT attach the Safety Rope to the thin part of the cord.
5) Press the Safety Pod suction cup FIRMLY in the lower corner on the opposite side of the
glass you are cleaning. Make sure the Safety Pod suction cup is securely in place.
6) Place WINBOT on the window, close the window if cleaning the outside of the window, and
start WINBOT.
7) After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the
unit OFF, insert finger into Air Release Trigger and pull up on it for 20 seconds until suction
has dimished.
Please read the entire contents of the Winbot Instruction Manual for detailed instructions.
1. IMPORTANT SAFETY INSTRUCTIONS
1) Should you be cleaning the outside of the window, you must use the Safety Pod. Read the
instructions on SAFETY POD use in your Instruction Manual.
2) When removing the Winbot, grasp the handle ofthe unit and move the switch under the handle
to the left – OFF position, and while still grasping the unit, insert tinger into the Air Release
trigger and Pulling up on it, remove the unit from the window when the suction has diminished.
3) Place the Winbot horizontally on the window and about 10 cm from the lower corners of the
window.
4) The unit may NOT be used outside while raining, snowing or colder than 5 °C as it will
damage the product and could cause electrical problems.