ECS GF7050VT-M5

35
Introducing the Motherboard
Power Management Setup
This page sets up some parameters for system power management operation.
Select the ACPI state
used for System Sus-
pend.
Help Item
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type S3 (STR)
Soft-off by PWR-BTTN Instant Off
PWRON After PWR-Fail Power Off
Resume By PCI/PCI-E/Lan PME Disabled
Resume By USB (S3) Disabled
Resume By PS2 KB (S3) Disabled
Resume By PS2 MS (S3) Disabled
Resume On Ring Disabled
Resume on RTC Alarm Disabled
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
: Move
mnlk
Parallel Port IRQ (IRQ7)
ECP Mode DMA Channel (DMA3)
Parallel Port Mode (ECP)
Use this item to set the parallel port mode. You can select Normal (Standard Parallel
Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or EPP &
ECP.
Use this item to assign the DMA Channel under ECP Mode function.
Use this item to assign IRQ to the parallel port.
Press <Esc> to return to the main menu setting page.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
ACPI Suspend Type (S3(STR))
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.