ECS HDC-M - Page 38

34
Using BIOS
Parallel Port (Enabled)
Use this item to enable or disable the parallel LPT or LPTE port.
Device Settings (IO=3F8h;IRQ=5)
Use this item to setting devices parameter.
Change Settings (Auto)
Use this item to change the settings automatically.
Device Mode(Standard and B1-dire...)
This item allows you to select the device mode for a better operation environment.
Press <Esc> to return to the Super IO Configuration Menu page.
Press <Esc> to return to the Advanced Menu page.
Parallet Part O Configuration
Parallel Port [Enabled]
Device Settings IO=378h; IRQ=5;
Change Settings [Auto]
Device Mode [Standard and B1-dire...]
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
Version 2.10.1208. Copyright (C) 2010, American Megatrends, Inc.
+/- :Change Opt.
Enter : Select
F1:General Help
lk
mn
:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Enable or Disable Parellel
Port (LPT/LPTE)
Main Advanced Chipset M.I.B III Boot Security Save & Exit
f Parallel Port Configuration
Use this item to show the information of Parallel port configuration.