38
Using BIOS
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have
installed in your system.
M.I.B III Menu
Memory Clock (Auto)
This item is used to set the memory clock.
Memory Mode (Auto)
This item is used to set the memory mode.
=
Main Advanced Chipset M.I.B III Boot Security Save & Exit
Memory Clock [Auto]
Memory Mode [Auto]
CAS# Latency (tCL) 8 CLK
RAS# to CAS# Delay (tRCD) 8 CLK
Row Precharge Time (tRP) 8 CLK
RAS# Active Time (tRAS) 20 CLK
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
This Option Allows User to
select different Memory Clock.
Default value is 400Mhz.
Version 2.10.1208. Copyright (C) 2010, American Megatrends, Inc.
+/- :Change Opt.
Enter : Select
F1:General Help
lk
mn
:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Main Advanced Chipset M.I.B III Boot Security Save & Exit
CAS# Latency (tCL) (8 CLK)
This item determines the operation of DDR SDRAM memory CAS (column address
strobe). It is recommanded that you leave this item at the default values. The 2T
setting requires faster memory that specifically supports this mode.
Row Precharge Time (tRP) (8 CLK)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
RAS# to CAS# Delay (tRCD) (8 CLK)
This item specifies the RAS# to CAS# delay to Rd/Wr command to the same bank.
RAS# Active Time (tRAS) (20 CLK)
This item specifies the RAS# active time.
To Next Page
Loading...
Need help?
General
