EDAN iM70 - 24.3 Recorder Operations and Status Messages

Patient Monitor User Manual Recording
- 203 -
Recording Type Description/ Procedure
Ventilation Calculation result
recording
Select Menu > Common Function Calculation >
Ventilation, click Record to start recording.
Renal Function Calculation
result recording
Select Menu > Common Function > Calculation > Renal
Function, click Record to start recording.
12-lead analysis recording Select ECG Setup > 12-L Review, click Record to start
recording.
C.O. measurement recording Select C.O. Option > C.O. Measure, click Record to start
recording.
Frozen waveform recording In the Freeze window, click Record to start recording.
ST View recording In the ST View window, click Record to start recording.
QT View recording In the QT View window, click Record to start recording.
To manually stop recording, click Record again in the related windows.
The recorder will stop recording in the following situations:
 The recording task is finished.
 No paper in the recorder.
 Malfunction stops the recorder from running properly.
 The monitor enters into standby mode.
NOTE:
1 You can also use the button
on the front panel or select shortcut key to
manually start or stop recording.
2 For waveforms with sweep of 6.25 mm/s, after entering freeze status, the recording
speed will automatically be adjusted to 12.5 mm/s. Users can modify the recording
speed according to their actual needs. The options are 12.5 mm/s, 25 mm/s and 50
mm/s.
3 In DEMO mode, the waveform amplitude does not change with the adjustment of
gain in CO
2
and IBP real-time recording.
24.3 Recorder Operations and Status Messages
24.3.1 Record Paper Requirement
Only standard thermosensitive record paper can be used: otherwise the recorder may not function,
the recording quality may be poor, and the thermosensitive print head may be damaged.