EDAN iM70 - Setting Keyboard Languages; Calibrating Screens; Disabling the Touch Screen; Using the Barcode Scanner

Patient Monitor User Manual Basic Operation
- 32 -
3.8 Setting Keyboard Languages
The monitor is equipped with Chinese keyboard, English keyboard and Russian keyboard. To
change the keyboard language, select Menu > Maintenance > User Maintain > Keyboard
Language, then select the desired language from the list.
NOTE:
The keyboard language will restore to the default language when the system language
changes. User can change the keyboard language as needed.
3.9 Calibrating Screens
To calibrate the screen, please refer to the following steps:
1. Select Menu > Maintenance > User Maintain, input the user password, and select
TouchScr Calibration on the User Maintain menu. User can also enter into calibration
interface through pressing shortcut key F9 in connected keyboard.
2. The symbol appears on the screen.
3. Click on the central point of the symbol .
NOTE:
1 If calibration file is lost or damaged, the monitor will automatically enter into screen
calibration interface.
2 In the screen calibration interface, the screen turns gray and no measurement data
can be displayed.
3.10 Disabling the Touch Screen
The user can disable touch screen operation by selecting and holding the permanent key
for three seconds. A message of Screen Locked and the symbol will be displayed at the
bottom of screen. To enable the touch screen operation, select the symbol
by using the knob.
3.11 Using the Barcode Scanner
To enter the barcode setup menu, please select Menu > Maintenance > User Maintain. After
entering the required password, select Other Setups > BarCode Setup. Then the user can set
MRN, last name, first name and so on.
User can also check relevant scanner device information or delete certain barcode scanner in
User Maintain > Scanner Management.
If the scanner is connected for the first time, the monitor will pop up a confirmation message to
ask user whether the new USB device is added as scanner. Choose Scanner to add the barcode
scanner to the scanner management list and enable the barcode scanning. Choose Keyboard to
enable the keyboard entry. Please refer to Chapter Accessories for the recommended scanner.