EDAN SONOTRAX Basic - Charging NI-MH Batteries

SONOTRAX(2009) Series Ultrasonic Pocket Doppler User Manual
39
according to local regulations.
New alkaline batteries with identical specifications
are required. Install them to the Doppler as
introduced in section 3.2.
WARNING
DO NOT CHARGE THE ALKALINE BATTERY.
3.8.3 Charging the NI-MH Batteries
When the rechargeable NI-MH batteries are low in
energy,
1) Take the NI-MH batteries out from the
main unit by using the procedures described
in section 3.2 Installing/Replacing Battery.
2) Replace them with new batteries of
identical specifications, or charge them with
a NI-MH battery charger that meets the
following specifications:
Input: AC 100-240 V, 50 Hz/60 Hz
Output: DC 1.45 V*2, 500 mA
理邦保密文件
EDAN CONFIDENTIAL