185
Specify a VLAN ID for each SSID.
Enable/disable auto channel selection.
Enable: Auto channel selection will automatically set the
wireless channel for the AP’s 2.4GHz frequency based on
availability and potential interference.
Disable: Select a channel manually as shown in the next table.
Select a range to which auto channel selection can choose
from.
Select a time interval for how often the auto channel setting
will check/reassign the wireless channel.
Check/uncheck the “Change channel even if clients are
connected” box according to your preference.
Select the channel bandwidth:
20MHz (lower performance but less interference); or
40MHz (higher performance but potentially higher
interference); or
Auto (automatically select based on interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
When auto channel is disabled, configurable fields will change. Select a
wireless channel manually:
To Next Page
Loading...
Need help?
General
