200
Enable or disable the AP’s 5GHz wireless radio. When disabled,
no 5GHz SSIDs will be active.
Wireless standard used for the AP.
Combinations of 802.11a, 802.11n & 802.11ac can be selected.
Select how many SSIDs to enable for the 2.4GHz frequency
from the drop down menu. A maximum of 16 can be enabled.
Enter the SSID name for the specified SSID (up to 16). The SSID
can consist of any combination of up to 32 alphanumeric
characters.
Specify a VLAN ID for each SSID.
Enable/disable auto channel selection. Auto channel selection
will automatically set the wireless channel for the AP’s 5GHz
frequency based on availability and potential interference.
When disabled, configurable fields will change as shown
below:
Select a range to which auto channel selection can choose
from.
Select a time interval for how often the auto channel setting
will check/reassign the wireless channel.
Check/uncheck the “Change channel even if clients are
connected” box according to your preference.
Select the channel bandwidth:
20MHz (lower performance but less interference); or
Auto 40/20 MHz; or
Auto 80/40/20 MHz (automatically select based on
interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
To Next Page
Loading...
Need help?
General
