39
Enable or disable the AP 2.4GHz wireless radio. When
disabled, no 2.4GHz SSIDs will be active.
Wireless standard used for the AP.
Combinations of 802.11b, 802.11g & 802.11n can be selected.
Select how many SSIDs to enable for the 2.4GHz frequency
from the drop down menu. (A maximum of 16 can be
enabled)
Enter the SSID name for the specified SSID (up to 16). The
SSID can consist of any combination of up to 32 alphanumeric
characters.
Specify a VLAN ID for each SSID.
Enable/disable auto channel selection.
Enable: Auto channel selection will automatically set the
wireless channel for the AP2.4GHz frequency based on
availability and potential interference.
Disable: Select a channel manually as shown in the next table.
Select a range to which auto channel selection can choose
from.
Select a time interval for how often the auto channel setting
will check/reassign the wireless channel.
Check/uncheck the “Change channel even if clients are
connected” box according to your preference.
Select the channel bandwidth:
- 20MHz (lower performance but less interference).
- 40MHz (higher performance but potentially higher
interference).
- Auto (automatically select based on interference level).
This is a series of rates to control communication frames for
wireless clients.