83
before you do this, and then click this button to reset all
settings.
NOTE: IP address will be reset to default value
‘192.168.2.3’ also. You’ll need to change the IP address
setting of your computer if the IP address of your
computer does not begin with ‘192.168.2’, and subnet
mask is not ‘255.255.255.0’, or you’ll not be able to
connect to this IP camera again.
LED Light OFF Switch the LED light of this IP camera off, so ‘LAN’ and
‘WLAN’ LED on the IP camera will stop working, in case
you don’t want other people know the camera is
transferring data.
You can click this button again to switch LED lights on
again.
After all settings are completed, click ‘OK’ to save settings, or click ‘Cancel’ to abort
and discard changes.
To Next Page
Loading...
