Edirol PC-50 - Getting Connected and Installing Drivers (Macintosh); Mac OS X Driver Installation

27
Getting Connected and Installing
Drivers (Macintosh)
If the “Authenticate” dialog box appears during the installation, input the
password and click “OK.”
1
Disconnect all USB cables other than those for your keyboard and mouse,
and restart your Macintosh.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
3
In the Driver (Mac OS X) folder of the CD-ROM, double-click
PC50USBDriver.pkg .
* A message such as “This Installer package needs to...” may appear.
Click “Continue.”
4
The display will indicate “Welcome to the EDIROL PC-50 Driver
Installer.” Click [Continue] .
5
The display will indicate “Select a Destination.”
Click the drive in which the operating system is installed to select it, and then
click [Continue] .
6
The display will indicate “Easy Install.”
Click [Install] or [Upgrade] .
7
The display will indicate “Installing this software requires you to restart
your computer when the installation is done.”
Click [Continue Installation] .
8
The display will indicate “The software was successfully installed.”
Click [Restart] to restart your computer.
This completes installation of the PC-50 driver.
Next, make MIDI device settings. (
→
Setting the driver (p. 28))
Mac OS X users
Installing the driver
The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
• Mac OS X users......................................................................... (p. 27)
• Mac OS 9 users ......................................................................... (p. 30)
What you actually see on
your computer screen may
b
e different, depending on
your computing
environment and the
operating system you’re
using.
Select your startup disk as
the drive.
PC-50_e.book 27 ページ ２００５年１１月１０日 木曜日 午前１０時３３分