EDM Solution-8 - Arming in Away Mode; Arming in Stay Mode

Solution-8 Operators Manual Page 11
MA800O3C.DOC
El
ectronics Design & Manufacturing
Arming in Away mode
+
or
0
+
To arm the system in AWAY mode, key in your code followed by AWAY button.
The AWAY indicator will illuminate, two beeps will be heard and your pre programmed
exit time will now begin.
At the end of this exit time any unsealed zone will be excluded, for example if a
window is left opened.
If the window is closed, this zone now becomes an active part of the system. Opening
the window after this time will cause an alarm condition.
If the AWAY indicator does not illuminate and a long beep is heard, forced arming is
not permitted. If this is the case then you must ensure that all zones are sealed or
manually isolated before the system will arm.
Arming in Stay mode
+
or
0
+
STAY mode is when the system is armed with predefined zones automatically isolated
(these zones must be defined by your installer).
When there is a need to arm the system perimeter only, this mode is extremely handy. It
automatically disables the interior detection zones allowing for movement within the
protected area while at the same time arming the perimeter zones.
To activate the system in STAY mode key in your code followed by the STAY button.
The STAY indicator will illuminate and two beeps will be heard. Any zones that have
been programmed for STAY mode will be automatically isolated and their respective
indicators will begin to flash slowly until exit time expires. At the end of exit time the
zone indicators will extinguish.
The pre programmed exit timer will now start. When this timer expires, any unsealed
zone, say a window with a reed switch being left open, will be ignored at the end of exit
time and placed into automatic exclusion.
If the window is then closed, this zone becomes an active part of the system. Opening
the window after this time will cause an alarm condition.
If the STAY indicator does not illuminate and a long beep is heard this means that
forced arming is not permitted. Any unsealed zones will need to be sealed or manually
isolated before the system will arm.
Provided for Download by www.bendigosecurity.com.au