Page 22 Solution-8 Operators Manual
Electronics Design & Manufacturing
M
A800O3C.DOC
Remote Arming via the
Telephone Line
This function allows you to arm the system from anywhere in the world via the
telephone. For obvious security reasons the system cannot be disarmed using this
method.
To arm the system simply call the
Solution-8
on the telephone number that it is
connected to. The
Solution-8
will answer the incoming call after a pre programmed
number of rings and two beeps will be heard.
Hold the EDM phone controller to the mouth piece of the telephone and press the button
on the controller. The tone generated by the phone controller will arm the system and
one long beep will be heard to indicate that the system has become armed.
Now hang up the telephone and the system will remain armed.
If the
Solution-8
control panel does not answer the call, this means that the system
is already armed.
Where both remote arming and upload/download have been selected, the system may
answer the call expecting the download computer, however this is easily noticed as the
tone heard will be constant and not the usual pulsing tone as is required for remote
arming.
NOTE:
In situations where both upload/download and telephone remote arming are selected the
Solution-8
will answer for remote arming if the system is disarmed. If the system
is armed the
Solution-8
will answer in the upload/download mode where it will
start looking for the upload/download computer.
To Next Page
Loading...