Page 16 Solution-8 Operators Manual
Electronics Design & Manufacturing
M
A800O3C.DOC
Console Panic Alarm
A PANIC ALARM can be triggered by pressing any two buttons in the outside columns
simultaneously on the console. The buttons must be horizontally adjacent.
This function can be programmed by the installer to either be a silent or an audible
alarm. Once the panic alarm has been initiated it will be sent via the dialler to the
monitoring station.
Example;
Press buttons '1' and '3', '4' and '6' or '7' and '9' simultaneously to cause
a panic alarm.
NOTE:
A panic alarm is a 24 hour alarm and can be activated any time of the day and no visual
display will be given by the console to indicate that a panic alarm has been activated.
However a long audible beep will be given at your console to indicate that your panic
request has been accepted.
Console Tamper
An alarm can be triggered if the console is being tampered with. Such an event
might be someone repeatedly entering the incorrect code.
The number of incorrect attempts that are required before triggering this alarm
would be programmed by your installer.
The alarm can be programmed to be an audible or silent event.
Auxiliary Codes
+
The
Solution-8
has two auxiliary codes which can be programmed to do many
different functions. For example you could have a code that opens a computer room
door where restricted access is required.
It should be noted that Auxiliary codes only operate when the system is in the disarmed
state.
When an auxiliary code is entered a pre-programmed sequence of events will occur.
This sequence will have been programmed by your installer.
To activate an auxiliary code simply key in your programmed auxiliary code followed
by the AWAY button, two beeps will be heard and the programmed events will occur.
To Next Page
Loading...