Solution-8 Operators Manual Page 17
MA800O3C.DOC
El
ectronics Design & Manufacturing
Domestic Dialling
Programming
+
2
+
There are 32 data locations set aside for domestic dialling, each of which is capable of
storing 1 digit. This will allow up to four 7 digit phone numbers to be programmed.
To program the desired phone numbers, first ensure the system is disarmed and that
there are no alarm memories present. If this in not the case then turn the system on and
off to clear and alarm memories.
Enter the Master code + 2 + the AWAY button. Three beeps will be heard and the
STAY and AWAY indicators on the console will flash simultaneously indicating a
successful entry to the domestic phone number programming mode.
If one long beep is heard entry has been denied and you should check with your installer
to see if domestic dialling has been enabled on your system.
After a successful entry, if phone numbers have already been programmed, the panel
will begin to display the numbers via the system console using the zone indicators.
The first number will be displayed for two seconds and then a beep will be heard as the
next number is displayed. You may watch as all stored numbers are displayed before
programming any new numbers, or start to program a new phone number by simply
entering the new number.
After all the digits in the first phone number have been entered, press the STAY button
to indicate the end of the first phone number.
You may now enter a second, third or fourth phone number if required by following the
above procedure.
NOTE:
If there is more than one phone number programmed and you wish to change one of
them, then you will need to re-program all of the stored phone numbers as well as the
new number.
When all required phone numbers have been programmed, exit the programming mode
by pressing the AWAY button.
If at any time you wish to view the stored numbers then enter the Master code + 2 + the
AWAY button.
To Next Page
Loading...